With Windows 95 and earlier versions of Windows and MS-DOS, a FAT16 partition table was used that only allowed up to a 2 gigabyte partition. While larger hard drives can be used, the drive would need to be split into multiple partitions without any third-party software.

Windows 95 OSR2

The second release of Windows 95 (OSR2) and later versions of Windows support a new FAT called FAT32. This fat table supported drives upward of 32 gigabytes. To see more than 2 gigabytes, you need to either have Windows 95 OSR2, Windows 98 or a later version of Windows.

  • How to determine the version of Windows on a computer.

FAT32 and Windows 98

If you have an operating system that supports FAT32, to enable FAT32 support, you must delete and recreate the partitions using fdisk and enable large disk support. If you have Windows 98, you can convert the hard drive to FAT32 support by following the steps below.

  • Click Start, Programs, Accessories.
  • Click System Tools and then click Drive Converter (FAT32).

It’s important to know that if you convert the hard drive to FAT32, it only converts the two gigabyte partition and does not enable the computer to see over two gigabytes. To see the complete hard drive, you must run fdisk and delete and recreate all partitions.

Using partition utility

Alternatively, if you don’t have an operating system that supports FAT32 or you don’t want to erase your information from your hard drive, there are software options. For instance, you can also download the utility Partition Magic and use it to manage the hard drive and enable FAT32 support.

  • Why can’t I see over 8.4 GB on my hard drive?
  • Why can’t my computer boot with a hard drive over 33.8 GB?
  • Why does Windows 95 not support hard drives over 32 GB?
  • Hard drive help and support.