Difficulty

Easy

Steps

7

Time Required

                          10 - 15 minutes

Sections

1

  • Water Filter
  • 7 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackWhirlpool Refrigerator

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Water Filter
  • Pull the water filter door in the base grill open.

Pull the water filter door in the base grill open.

1024

Step 2

  • As the door opens, the filter gets ejected out.
  • When the filter is fully ejected, go ahead and pull the filter out.
  • A towel is suggested as water might spill while pulling the old filter out.

As the door opens, the filter gets ejected out.

When the filter is fully ejected, go ahead and pull the filter out.

A towel is suggested as water might spill while pulling the old filter out.

Step 3

  • Get the new filter out of its packaging.
  • Remove the covers from the O-rings while the O-rings still being in place.

Get the new filter out of its packaging.

Remove the covers from the O-rings while the O-rings still being in place.

Step 4

  • Align the new filter with the filter housing and insert filter into place.
  • The arrows should be facing the same way.

Align the new filter with the filter housing and insert filter into place.

The arrows should be facing the same way.

Step 5

  • Close the filter cover door completely to snap the filter into to place correctly. You will hear a snap!

Close the filter cover door completely to snap the filter into to place correctly. You will hear a snap!

Step 6

  • Flush the water system by holding the water dispenser for 5 seconds and releasing for 5 seconds repeating this step until water begins to flow.
  • After water flowing, get at least a total of 3 gallons dispensed in order to see full flushed water results.

Flush the water system by holding the water dispenser for 5 seconds and releasing for 5 seconds repeating this step until water begins to flow.

After water flowing, get at least a total of 3 gallons dispensed in order to see full flushed water results.

Step 7

  • Lastly you will need to reset the filter indicator by pushing the switch 5 times in a row.
  • When the filter indicator is reset, the light should change from red to green.

Lastly you will need to reset the filter indicator by pushing the switch 5 times in a row.

When the filter indicator is reset, the light should change from red to green.

After flushing the water system completely, get ready to have some refreshing water with a cup of ice freshly made with the new installed water filter.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    brenda lopez

Member since: 10/05/2021

198 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       CSU Los Angeles, Team 11-30, Grodsky Fall 2021                        

                                                  Member of CSU Los Angeles, Team 11-30, Grodsky Fall 2021 



                    CSULA-GRODSKY-F21S11G30                     


                                            1 Member                     


                                            1 Guide authored

SewFrau58 - Sep 5, 2022

Reply

Changed filter but now water is not coming out of the dispenser. Installed filter correctly per pictures. What could be the problem?

Fredric - 2 hours agoJan 24, 2023

Reply

You will have air in the system after changing the filter. Make sure you did turn the water on. Run the water dispenser until water pushes the air out. Run the water until it clears.