Difficulty

Easy

Steps

6

Time Required

                          10 - 15 minutes

Sections

1

  • LED Light
  • 6 steps

Flags

0

  • BackWhirlpool Refrigerator

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Before ordering a new LED I recommend taking it out and inspecting, this way you can see if its an issue with the refrigerator or the light. Before starting this guide be sure to unplug the refrigerator to turn off power.

What you need

Step 1

              LED Light
  • Make sure electricity is off, do this by unplugging your refrigerator.

Make sure electricity is off, do this by unplugging your refrigerator.

1024

Step 2

  • Detach the front two tabs of the light, using an opening tool on the perimeter of the light where it attaches to the ceiling of the refrigerator.
  • Do this on the back tabs of the light as well.
  • It may take some force but be careful not to break the tabs.

Detach the front two tabs of the light, using an opening tool on the perimeter of the light where it attaches to the ceiling of the refrigerator.

Do this on the back tabs of the light as well.

It may take some force but be careful not to break the tabs.

Step 3

  • Disconnect the wire connectors to fully remove light.
  • Gentling unplug both wires, does not matter which one you do first.
  • Once you have them off the LED will be freed.

Disconnect the wire connectors to fully remove light.

Gentling unplug both wires, does not matter which one you do first.

Once you have them off the LED will be freed.

Step 4

  • Unbox the new LED light

Unbox the new LED light

Step 5

  • Install the new LED light by putting back the wire connectors.
  • Reattach the corresponding connectors to the LED.

Install the new LED light by putting back the wire connectors.

Reattach the corresponding connectors to the LED.

Step 6

  • Put the LED light back into place.
  • Push the LED light into the position it was before, use needed force.

Put the LED light back into place.

Push the LED light into the position it was before, use needed force.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Erick Celis

Member since: 10/11/2020

163 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Linn Benton Community College, Team S1-G4, Johnson Fall 2020                        

                                                  Member of Linn Benton Community College, Team S1-G4, Johnson Fall 2020 



                    LBCC-JOHNSON-F20S1G4                     


                                            1 Member                     


                                            1 Guide authored